Logic device/transceiver/encoder

The MC74C4040A has the same pin-out as the standard CMOS MC14040. The device inputs are compatible with standard CMOS outputs; pull-up resistors are included for compatibility with LSTTL outputs. The device consists of 12 master-slave flip-flops. The output of each flip-flop feeds the next flip-flop, with half the frequency at each output of the previous one. The state counter advances once on the negative going edge of the clock input. Reset is asynchronous and active high. Due to internal ripple delays, the state changes of the Q outputs do not occur simultaneously. Therefore, the decoded output signal is prone to decode spikes and may have to be gated with the HC4040A's clock for some designs.

SN74LVC1G11 Single 3-Input Positive-AND Gate

High-speed CMOS logic co-directional octal bus transceiver with 3-state outputs 20-SOIC -55 to 125

SN74TVC3306 Dual Voltage Clamp

SN74LVC2G08 Dual 2-Input Positive-AND Gate

The NC7S04 is a high performance single CMOS inverter. Advanced silicon-gate CMOS fabrication process ensures high-speed, low-power circuit operation over a wide range of VCC. ESD protection diodes are built-in to protect the VCC and GND rails of the input and output. Three stages of gain between input and output ensure high noise immunity and reduce sensitivity to input edge rates.

The NC7S04 is a high performance single CMOS inverter. Advanced silicon-gate CMOS fabrication process ensures high-speed, low-power circuit operation over a wide range of VCC. ESD protection diodes are built-in to protect the VCC and GND rails of the input and output. Three stages of gain between input and output ensure high noise immunity and reduce sensitivity to input edge rates.

The AC/ACT32 watch contains four 2-input OR gates.

SN74121 Monostable Multivibrator with Schmitt Trigger Input